Custom Wood Bats

Foam Padded Custom Headboards and How to Make Them?
Foam padded custom headboards and how to make them?
How to make foam padded headboard.
Materials:
• Styrofoam in three 2″ thick x 12″ wide x 36″ long sheets
• Fabric: 3 yds. of 45″ fabric with small print or a solid for shirred border and back .
-1 yd. of 45″ fabric with large print for center panel
-1 yd. of 45″ fabric with small print in contrasting color for cording
-3 yds. of medium white cotton cording, (3 yds. of ready-made cording or braid can be used instead)
• Batting – 2 yds. of 10-oz. thick flame retardant quilt batting
Tools: 1″-1 1/2″ putty knife
low melt glue gun and clear glue sticks
serrated kitchen or steak knife
used candle
U-pins or fern pins
2 1/2″ green or white wood picks (available in floral department)
several T-pins
scissors, black marker, blunt pencil
Steps:
1. Joining Styrofoam: Sand edges of foam to be joined by rubbing pieces together lightly. Insert three wood picks into edge of one piece to be joined. Working on a flat surface, move edge of other board slightly onto the wood picks. Using low-melt glue, cover picks and edges with glue and slowly push pieces together. Hold in place snugly for a few seconds. Any number of pieces can be joined in this manner to make headboard as large as desired.
2. Cutting Foam: Mark area to be cut with felt-tip pen. Lay board onto flat table top, with longest end on flat surface, and side to be cut resting just beyond end of table. Use serrated knife waxed with candle. Holding foam portion on table, cut away excess. Use even, smooth strokes and keep knife perpendicular to table top. Sand away ragged edges by rubbing back and forth with a scrap of foam. This also enhances the fit with other pieces.
• Tucking Technique: Draw a line where you wish the fabric or trim to be tucked into the foam. Score this line with a blunt pencil so that you can feel the line with your fingertip when a piece of fabric is laid on top. Cut fabric piece at least 1/2″ larger than the area to be covered to allow for tucking into foam. Lay fabric so that seam allowance rests over the score line. Using putty knife, punch fabric straight down into foam at score line tucking. When tucking the second fabric into the same score, always run a bead of glue for a good hold.
• Making Cording to Match: Ready-made cording can be purchased in a number of colors at any fabric store. Braids, cords, and ribbons can also be used as finishing trims. To make matching cording, cut fabric into 1 1/2″ bias strips. Sew these strips together to make one long piece. Fold in half over the cotton cording and, with a zipper foot on the machine, sew close to the cording (see diagram).
Constructing the Headboard:
• Styrofoam Base (finished base before cutting point will be 30″ x 40″)
1. Cut away 6″ from each piece of foam (see above directions for “Cutting Foam”).
2. From these scraps, cut 2 pieces 4″ x 12″ and 1 piece 4″ x 6″.
3. Join all pieces (see directions given above for “Joining Foam”) to make a base 30″ x 40″ (see diagram).
4. Following diagram and using serrated knife, cut away the pieces at each side of top to make peaked headboard.
5. Using a scrap of foam to sand, slightly round all edges of base.
6. Measure a 4″ border around all edges of base except the bottom. Draw line with black marker and score with blunt pencil. This will be the tucking line for the shirred border (see diagram).
• Fabric and Batting
1. Cut batting as follows: one piece to fit center section of base (32″ x 26″), two pieces 7″ x 21″ to wrap lower sides, two pieces 7″ x 22″ to wrap each side of top.
2. Run a bead of glue along side, just inside of tucking line and adhere batting. Fold over edges and pull to back. Glue in place. Do this for the top section as well. When folding over ends, cut away some excess before folding and gluing. This will make a smooth finish.
3. Cut center piece of batting so that it will fit about 1/4″ inside tucking lines. Remove and set aside while tucking the shirred edges.
4. Cut fabric as follows: border fabric (small print), 6 pieces 11″ x width of fabric; backing fabric (small print), 1 piece 30″ x 40″; center panel (large print), 1 piece 34″ x 30″; cording (companion print) as in directions above
Tucking Headboard:
1. Read instructions above on tucking before beginning. A bead of glue should be run along the score as you tuck. it is best to tuck only about 3″ at a time as glue dries quickly.
2. Lay base on a flat surface. Begin at top point of headboard. Fold under a small seam allowance. Place edge of fabric over tucking line and tuck into score with putty knife. Gather fabric as you tuck (see picture). This piece should cover about 3/4′s of the top border. When end of fabric piece is reached, turn under a small seam allowance and tuck into foam.
3. Turn board to back. Bring fabric piece snugly over edge and batting and tuck into foam in back, keeping as straight a line as possible, and arranging gathers so that it looks attractive from the front. Check often to be sure the front shirring looks attractive.
4. Continue with next piece, overlapping first piece slightly. Allow extra fabric gathers when turning corner. When tucking back, be sure corner does not look smooth but has gathers when finished. The fabric that is pulled over corner may need to be glued at back rather than tucked. When end of shirred side is reached, fabric is folded over bottom, excess is cut away to allow for a smooth fold to back (see diagram).
5. Complete other side of headboard in same manner.
6. Return batting to center panel. lay large print fabric over center. Trim to fit panel, being sure to leave at least 1/2″ around all edges. Begin tucking at one side, adding glue in tucking seam as you go. Tuck opposite side, pulling snugly and then top, smoothing any wrinkles that appear. Pull fabric to back at bottom, and hold in place with “U” pins. Glue edges in place.
7. Make cording as directed above. Cut away most of seam allowance. Begin at bottom; leave enough cording to bring around to back. Glue cording into tucking trench, being sure the seam allowance goes into the trench and the cording rests on top.
8. Turn headboard to back, glue cording ends in place. cover back with extra fabric piece by folding under a seam allowance and gluing in place, approximately 1″ from edge, all the way around. This will cover the tucked back and add an attractive finish.
Hanging Headboard:
There are several methods of hanging this headboard. Measure as if hanging a picture, and mark two spots behind the bed about 24 inches apart. The headboard should sit just at the top of the mattress. Use long nails or screws that will protrude from the wall at least 1-1/2 inches. Mark corresponding spot on back of headboard and pierce fabric. Push headboard onto screws, flush with wall. Headboard may also be hung like a picture using U-pins placed in foam upside-down, and adding wire between. Once headboard is hung, it is quite firm and can be leaned against to read or watch television.
|
|
SOLID WOOD BASEBALL MINI SIZE BAT RACK UP 17 BATS 6 BALLS BLACK CUSTOM M DELUXE $26.99 |
|
|
Mizuno Custom Classic Maple MZM271 Wood Bat 32″ $79.99 |
|
|
Mizuno Custom Classic Maple MZM271 Wood Bat 33″ $79.99 |
|
|
Mizuno Custom Classic Maple MZM271 Wood Bat 34″ $79.99 |
|
|
Mizuno Custom Classic Maple MZM331 Wood Bat 33″ Brown $79.99 |
|
|
Mizuno BCC2000 Custom Classic C-21 Wood Bat 31″ 28 OZ. $24.97 |
|
|
SOLID WOOD BASEBALL MINI SIZE BAT RACK UP 17 BATS SHELF BLACK CUSTOM PT DELUXE $26.99 |
|
|
SOLID WOOD BASEBALL FULL SIZE BAT RACK UP 11 BATS 6 BALLS BLACK CUSTOM DELUXE $29.69 |
|
|
Cafe Doors by cafe Doors Emporium Prefit for 36 Finished Opening :: Beautiful Reclaimed Character :: Made of Exotic Wood – Cafe Doors Hinge Set Included (30 and 32 sizes available) Saloon Western Swinging Wood Bar Bat Wing Door $109.00 Our reclaimed wood style louvered cafe doors are master crafted from exotic wood and come unfinished – ready to paint or stain. The cafe door’s wood grain & color is akin to a cross between American Ash & Patagonian Maple with the beautiful characteristics of reclaimed wood. Cafe Door set comes as a pair with cafe doors hinges and installation instructions. Please allow up to 15 days for custom c… |
|
|
Cafe Doors Prefit for 30 Finished Opening :: Beautiful Reclaimed Character :: Made of Exotic Wood – Cafe Doors Hinge Set Included (32 and 36 sizes available) Saloon Western Swinging Wood Bar Bat Wing Door $99.00 Our reclaimed wood style louvered cafe doors are master crafted from exotic wood and come unfinished – ready to paint or stain. The cafe door’s wood grain & color is akin to a cross between American Ash & Patagonian Maple with the beautiful characteristics of reclaimed wood. Cafe Door set comes as a pair with cafe doors hinges and installation instructions. Please allow up to 15 days for custom c… |
|
|
Cafe Doors Prefit for 32 Finished Opening :: Beautiful Reclaimed Character :: Made of Exotic Wood – Cafe Doors Hinge Set Included (32 and 36 sizes available) Saloon Western Swinging Wood Bar Bat Wing Door $104.99 Our reclaimed wood style louvered cafe doors are master crafted from exotic wood and come unfinished – ready to paint or stain. The cafe door’s wood grain & color is akin to a cross between American Ash & Patagonian Maple with the beautiful characteristics of reclaimed wood. Cafe Door set comes as a pair with cafe doors hinges and installation instructions. Please allow up to 15 days for custom c… |
|
|
Conair PTM1 Teak Bath Mat $32.77 The Teak Shower matt provides comfortable, slip-free footing. Lightly coated with mineral oil to provide a beautiful nonslip finish, the durable, solid wood construction will last for years. It also resists fungi for a cleaner shower/bath environment…. |
|
|
ENERGIZER AA4 EVEREADY AA Alkaline Battery $0.19 Eveready Gold alkaline batteries last 3X’s longer than most batteries and are ideal for low to mid-drain devices such as, remotes, radios, calculators and motor driven toys.Item SpecificationsUnit of Sale4-PackBattery SizeAA… |
|
|
Grand Slam- Smuggler Flask Baseball Handle Walking Stick With Pine Wood Shaft $99.00 This patented Grand Slam Walking Cane is the ultimate gift for any baseball fan. The shaft of this walking stick is a replica of a baseball bat. The bottom portion unscrews to reveal a hidden hollow compartment that can hold either a glass flask or a rain poncho. The upper portion has a slender hole to hold the celebratory cigar. Other high quality features of the Grand Slam Walking Cane include a… |
|
|
mimulux Dark Fantasy Art – SLEEPING DEMON sleep woods forrest demon shedemon fantasy spirit dreaming bats mushrooms dreamland – Coffee Gift Baskets – Coffee Gift Basket $44.99 SLEEPING DEMON sleep woods forrest demon shedemon fantasy spirit dreaming bats mushrooms dreamland Coffee Gift Basket is measuring 9x9x4. Contains 15oz mug, BONUS free set of 4 coasters, biscotti and 5 blends of gourmet coffee. French Vanilla, Kenya AA, Decaf Colombian Supremo, Chocolate and Italian Roast Espresso elegantly presented in our signature black planet coffee gift box. A very nice and… |
|
|
Samsung Galaxy S II / SGH-T989 (Hercules) Protector Case Phone Cover – Black $4.01 This protector case is custom made for your device. It is made of a high quality plastic that provides great protection for your device. It comes with cutouts that are perfectly designed so that you are able to utilize every function of your phone. This case is perfect for those who want to add some visual flare to their phone and at the same time have the benefit of superb protection!… |
|
|
Mizuno Custom Classic Maple Bat (Mahogany, 33) $59.99 Mizuno Wood Bats…In The Hands Of The Best! Mizuno Classic Maple Wood Bats feature: A unique design created by Mizuno’s master craftsman Isokazu Kubota who has hand-crafted wooden bats for Mizuno for over 40 years A balanced bat design for maximum swing speed Mizuno Custom Classic Maple bats are hand selected in Japan Made of hard maple Pro cupped end Used by Major League Baseball all stars (incl… |
|
|
Mizuno Custom Classic Bamboo Bat (Natural, 33) $55.19 Mizuno Wood Bats…In The Hands Of The Best! Mizuno Classic Bamboo Wood Bats feature: A unique design by engineers with over 30 years of expertise in engineering bamboo bats Excellent training bat for extended bat life span Exceptional durability Hand selected in Japan from top quality bamboo Uses Mizuno’s exclusive microwave drying process to maximize consistency and performance Pro cupped end 90… |
Hello there. I am still really new on blogging and the entire things around this field. There are many jargons I still don’t understand. I’m not really sure I can write half decent to yours. I will read the entire site maybe I will be able to feel your writing style a little.